Two Glass sheets are attached to each other using adhesive material, The combination is siting on two points of contact at both ends ( one rolling and one stationary ), We are applying a vertical force F to the center of top glass and combination deflects. How do we reduce the deflection?
If you are in a boat in the middle of the pond and drop an anchor, how does the water level vary with respect to shore?
There’s a refrigerator in a closed room. If the refrigerator door is opened would the room get colder or warmer. Explain
If you have a cantilevered beam with a load at the unsupported end, what can you change about the beam to mitigate the effect of the load.
Given a force at the end of a cantilever beam, what is the shear stress at the wall?
Presented a component. How do you think its made? After answered that it is done by plastic injection moulding, further questions on the details were asked.
You have a sign hanging at the end of a straight aluminum beam with a square cross-section. You notice that there is significant deflection in the beam. What are some design modifications you can make to reduce the deflection? If you were then asked to change the beam's cross-sectional, would you increase the vertical or horizontal dimension and why?
If you had steel, stainless steel, and aluminum on the table, how would you tell them apart?
Young's Modulus
What are 4 ways to connect a plastic and a metal?
Viewing 21 - 30 interview questions