Design a circuit with 0V to 3.3V step at the input and negative 1ms pule at the output. Input: ___|----- CIRCUIT Output: -----|_____|------ Requirements: 1. Pulse,width,is,in,millisecond,range 2. Simple,and,low,cost 3. Indicate,every,component,used,clearly 4. Find,a,solution,that,does,not,use,logic, gates,,but,only,uses,transistors, (minimal,#,of,transistors) 5. Draw,a time,graph,of,all,of,the,nodes, in,the,circuit,that,are,switching.
Technical questions
No difficult questions were asked. The interview focused more on my technical skills and my grasp on RF Engineering fundamentals than on my behavioral aspects.
Questions about RF circuits and systems.
Since the interview was for a hardware position, they asked more software related questions than I expected but were all easy
Questions about set up and hold time
Design with Latches
verification design, given a structure to say what should be test and how to find the bugs
Analysis on zero and pole
Self introduction
Viewing 4051 - 4060 interview questions