Given two plates of a capacitor connected to a voltage source which side of each plate would be charged and what would be the polarity?
Analog Design Engineer Interview Questions
1,259 analog design engineer interview questions shared by candidates
Talk about yourself, questions about resume were asked, and draw a circuit you designed. The board in the interview room was used to analyze the circuit
RC, RL circuits, opamp gain bandwidth, bode plot, MOS Device characteristic, project related questions
What are some difficult situations faced in previous job and how do you handle it?
Describe operating principle of MOS Diff amplifier?
Clock non-idealities/timing violations, PVT, one-hot encoding, memory configurations
all about analog circuit design basics, 1. Mosfet channel formation and then Common gate, common source, common drain operations and question on that how it will works. 2. cascaded circuits analysis by putting some resistance or cap in between and tells us to analyse the schematic behaviour. 3. rest all questions are about my internship work which i worked on PLL, CDR, DFE, FFE.
About Layout designs and CMOS theory
Questions from circuit topologies to block level specifications, intuitional thinking about transistor level performance metrics based W/L etc, mismatch, noise, layout matching etc.
ESD latch up analog layouts RV PV
Viewing 451 - 460 interview questions